DELO Industrial Adhesives
Booth number: Second Floor - 211
www.delo.de
About us
DELO is a leading manufacturer of high-tech adhesives and other multifunctional materials as well as adhesive dispensing and curing technology. Its products are mainly used in the semiconductor, automotive, and consumer electronics industries. They can be found in almost every mobile phone and in most cars worldwide, for example in cameras, loudspeakers, electric motors, or sensors. Customers include Bosch, Huawei, Mercedes-Benz, Osram, Siemens, and Sony.
DELO's headquarters are in Windach, Germany, near Munich, with subsidiaries in China, Japan, Malaysia, Singapore, and USA, as well as representative offices and distributors in numerous other countries. The company employs a workforce of 1,160 staff and achieved revenues of €245 million in the last fiscal year.
-thumb.webp)
Address
DELO-Allee 1
86949 Windach
Germany
E-mail: christoph.braun@delo.de
Phone: +49 8193 9900-0
Internet: www.delo.de
Products & Services
Simultaneous dosing and curing with DELO-ACTIVIS
With the “Activation on the flow” process technology and DELO-ACTIVIS, DELO has developed an unique technology that combines dispensing and pre-activation by UV light in one step, saving not only time but also production costs. For DELO-ACTIVIS, special adhesives were developed based on epoxy resin. The patented DELO KATIOBOND FA products are provided with so-called “dual initiators”. Their distinctive feature is that they react to different wavelengths so that the adhesive cures more slowly or more quickly. The one-component adhesives are available with different mechanical properties and are highly resistant to media and temperature in the cured state. Activation on the flow is an efficient alternative to heat curing, dual curing and two-component curing.
IBOA-free medical adhesive for glucose monitoring sensors and other wearables
DELO PHOTOBOND MG4047 is designed for wearable medical applications such as glucose monitoring sensors (CGM). With a 230-MPa Young’s modulus and a 200% elongation at tear while maintaining a 9-MPa compression shear strength, DELO PHOTOBOND MG4047 manages to be both a highly flexible and decidedly strong adhesive. Its physical properties enable it to prevent common problems associated with wearable sensors, such as sensor drift, which can occur following potting. The curing properties of this light-curing adhesive are optimized for mass medical wearable production with a required irradiation time of as little as two seconds under a 365–400-nm LED light with an intensity of 1000 mW/cm². One of its main advantages is that it is free of IBOA, reducing the risk of adverse reactions. DELO PHOTOBOND MG4047 also demonstrates its nontoxicity through its biocompatibility, meeting the requirements outlined in the DIN EN ISO 10993-5 cytotoxicity test.